Hyundai Elantra Owners Manual
Hyundai Elantra: Wipers and washers
Cabin air filters improve air quality inside your Hyundai Elantra. This section explains when and how to replace the filter for clean interior airflow.
A :Wiper speed control
· MIST – Single wipe
· OFF – Off
· INT – Intermittent wipe
· LO – Low wiper speed
· HI – High wiper speed
B : Intermittent wipe time adjustment
C :Wash with brief wipes
Windshield wipers
Operates as follows when the ignition switch is turned ON.
MIST : For a single wiping cycle, push the lever upward and release it with the lever in the OFF position. The wipers will operate continuously if the lever is pushed upward and held.
OFF : Wiper is not in operation
INT : Wiper operates intermittently at the same wiping intervals. Use this mode in a light rain or mist. To vary the speed setting, turn the speed control knob(1).
LO : Normal wiper speed
HI : Fast wiper speed
✽ NOTICE
If there is heavy accumulation of snow or ice on the windshield, defrost the windshield for about 10 minutes, or until the snow and/or ice is removed before using the windshield wipers to ensure proper operation.
CAUTION
When starting the vehicle in winter, set the wiper switch in the OFF position. Otherwise, wipers may operate and ice may damage the windshield wiper blades. Always remove all snow and ice and defrost the windshield properly prior to operating the windshield wipers.
Windshield washers
In the OFF position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles.
Use this function when the windshield is dirty.
The spray and wiper operation will continue until you release the lever.
If the washer does not work, check the washer fluid level. If the fluid level is not sufficient, you will need to add appropriate non-abrasive windshield washer fluid to the washer reservoir.
The reservoir filler neck is located in the front of the engine compartment on the passenger side.
CAUTION
To prevent possible damage to the washer pump, do not operate the washer when the fluid reservoir is empty.
WARNING
Do not use the washer in freezing temperatures without first warming the windshield with the defrosters; the washer solution could freeze on contact with the windshield and obscure your vision.
CAUTION
- To prevent possible damage to the wipers or windshield, do not operate the wipers when the windshield is dry.
- To prevent damage to the wiper blades, do not use gasoline, kerosene, paint thinner, or other solvents on or near them.
- To prevent damage to the wiper arms and other components, do not attempt to move the wipers manually.
The wipers and washers in the Hyundai Elantra ensure clear visibility in rain, snow, or dirt-heavy conditions. Variable speed settings allow you to match the wiper speed to weather intensity. The washer system dispenses cleaning fluid across the windshield, activated by a simple lever or button. Wiper blades should be inspected for wear and replaced every six months to a year for optimal performance. During winter, it's important to lift blades off frozen windshields to prevent tearing or motor strain. Some models include rain-sensing wipers that automatically adjust based on precipitation levels. Rear wipers, if equipped, provide the same convenience for hatchback or sedan variants with sloped glass. Low washer fluid indicators help you refill in time to maintain safety. Proper function of this system is essential for long-distance travel and urban commuting alike. Maintaining it ensures you're prepared for sudden weather changes or unexpected road spray.
0.00981